Re: [RPRWG] about OPNET models for Gandalf
I'm confused. The attached note addresses Gandalf models. Are these models
the same as the proper ones for Darwin, are they a subset of the models
required for Darwin, or are they something else? Specifically, to what
extent do these models address the full range of capability addressed by
what is in our draft 0.1?
Thank you.
Best regards,
Robert D. Love
Chair, Resilient Packet Ring Alliance
President, LAN Connect Consultants
7105 Leveret Circle Raleigh, NC 27615
Phone: 919 848-6773 Mobile: 919 810-7816
email: rdlove@xxxxxxxx Fax: 208 978-1187
----- Original Message -----
From: "Pinar Yilmaz" <pinar@xxxxxxxxx>
To: <stds-802-17@xxxxxxxx>
Sent: Thursday, February 07, 2002 8:09 PM
Subject: [RPRWG] about OPNET models for Gandalf
> ATTENTION: OPNET users who are studying Gandalf models
> John Hawkins
> ---------------------------------------------------------
> A patch is released for Gandalf models which are available at:
> http://grouper.ieee.org/groups/802/17/member/rpr_release_bin_120701.zip
>
> The patch is attached to this e-mail as a zipped files.
> The patch contains four node models.
> The process models are NOT affected by this patch.
> Scenarios studying raw packet traffic behavior are also NOT affected.
> ---------------------------------------------------------
> Instructions for use:
>
> This patch contains four files:
>
> RPR_ethernet4_slip4_rpr_router_adv.nd.m
> RPR_ethernet_router_adv.nd.m
> RPR_routing_wkstn.nd.m
> RPR_wkstn.nd.m
>
> These files must replace the original files by the same names.
> After extracting the zipped file, copy the patch files to the RPR model
> directory to replace the original files.
> ---------------------------------------------------------
> NOTE:
> The presentation by Vassan Karighttam "Delay and Jitter for Darwin with
> 2 TB" as was presented in January'02 Interim meeting in Orlando, Florida
> contained simulation results. Those results were obtained using Opnet
> Modeler version 7.0.C. The patch is necessary only for scenarios using
> Opnet Modeler version 8.0.B. Therefore, the presented results are NOT
> affected by this patch.
> ---------------------------------------------------------
> NOTE to John Hawkins:
> Please make the attached file available for download in the members
> area.
>
>
> Thanks,
> Pinar Yilmaz