Re: [STDS-802-3-EPOC] Evaluation Criteria and Requirements Ad Hoc Minutes
Marek,
Thanks for the clarification.
Best Regards,
Duane
FutureWei Technologies Inc.
duane.remein@xxxxxxxxxx
Director, Access R&D
919 418 4741
Raleigh, NC
From: Marek Hajduczenia [mailto:marek.hajduczenia@xxxxxx]
Sent: Wednesday, February 20, 2013 5:26 PM
To: Duane Remein; STDS-802-3-EPOC@xxxxxxxxxxxxxxxxx
Subject: RE: [STDS-802-3-EPOC] Evaluation Criteria and Requirements Ad Hoc Minutes
Duane,
Once the initial discovery and configuration is done, all you need is signaling from OLT to ONU indicating to enter the sleep mode. That takes one TLV / MAC Control message per cycle (or less, in case of some of the packages allowing continuous power saving that keep using the same power saving parameters).
So >> data is only required to enter/leave the "sleep" mode << is a correct assertion. The volume of information exchange is very limited.
Marek
From: Duane Remein [mailto:Duane.Remein@xxxxxxxxxx]
Sent: Thursday, 21 February, 2013 6:57 AM
To: STDS-802-3-EPOC@xxxxxxxxxxxxxxxxx
Subject: Re: [STDS-802-3-EPOC] Evaluation Criteria and Requirements Ad Hoc Minutes
One concern I have with using the SIEPON method to control power savings is the amount of data needed to support this method. If data is only required to enter/leave the "sleep" mode then this should not be an issue. If regularly scheduled messages are required then this should be taken into account.
Best Regards,
Duane
FutureWei Technologies Inc.
duane.remein@xxxxxxxxxx<mailto:duane.remein@xxxxxxxxxx>
Director, Access R&D
919 418 4741
Raleigh, NC
From: Shellhammer, Steve [mailto:sshellha@xxxxxxxxxxxxxxxx]
Sent: Wednesday, February 20, 2013 1:30 PM
To: STDS-802-3-EPOC@xxxxxxxxxxxxxxxxx<mailto:STDS-802-3-EPOC@xxxxxxxxxxxxxxxxx>
Subject: [STDS-802-3-EPOC] Evaluation Criteria and Requirements Ad Hoc Minutes
All,
Attached are the minutes from this morning's call and also the two presentations from Marek.
Steve
________________________________
<="" p="">
________________________________
<="" p="">
________________________________________________________________________
To unsubscribe from the STDS-802-3-EPOC list, click the following link:
https://listserv.ieee.org/cgi-bin/wa?SUBED1=STDS-802-3-EPOC&A=1