[802SEC] Ballot Recirculation, P802.15.3
Just letting everyone know we have started the second Sponsor Ballot
recirculation of the 802.15.3 Revision draft.
Cc: "C/LM/WG802.15 Project Staff Liaison"
Subject: Ballot Recirculation, P802.15.3
Dear IEEE P802.15.3 - Balloting Group Member:
This e-mail is to advise you of the opening of IEEE Standards Sponsor New
Ballot Recirculation - 2 for:
Title: Standard for High Data Rate Wireless Multi-Media Networks
Scope: This standard defines PHY and MAC specifications for high data
rate wireless connectivity (typically over 200 Mbps) with fixed, portable
and moving devices. Data rates are high enough to satisfy a set of
consumer multimedia industry needs, as well as to support emerging
wireless switched point-to-point and high rate close proximity point to
Purpose: The purpose of this standard is to provide for low complexity,
low cost, low power consumption, high data rate wireless connectivity
among devices supporting a variety of applications such as a set of
consumer multimedia industry needs, wireless switched point-to-point
applications in data centers, wireless backhaul/fronthaul intra-device
communications and a wide variety of additional use cases such as rapid
large multimedia data downloads and file exchanges between two devices in
close proximity, including between mobile devices and stationary devices
(kiosks, ticket gates, etc.), and/or wireless data storage
BALLOT OPENS: 16-Feb-2016
BALLOT CLOSES: 26-Feb-2016.
No votes and/or comments will be accepted after 11:59 p.m. Eastern Time
on the close date. Make sure you review the document, cast your vote, and
submit your comments before the closing date/time.
***** TO ACCESS THE DOCUMENT, SUBMIT YOUR VOTE, AND SUBMIT YOUR COMMENTS
1. Log onto myBallot (this link will bring you directly to the
"Manage myBallot Activity" screen) at
2. Locate P802.15.3
3. Click on the DRAFT# to open the draft/standard; click on the drop-down
box to change your vote; click on the comments link (under the Actions
column) to be taken to the ballot comments screen to submit your
Comments submitted for IEEE-SA Sponsor ballots are contributions to IEEE
standards development. By submitting comments, you agree to provide a
license to the IEEE for use of your comments (see Clause 7 of the IEEE-SA
Standards Board Bylaws and Clause 6.1 of the IEEE-SA Standards Board
*****ACCESSING SPONSOR BALLOT COMMENTS AND RESPONSES *****
To view ballot comments and responses from prior circulations of
the ballot (e.g., Initial Ballot, Recirculation 1, Recirculation 2,
1. Click the corresponding link in the box at the top of the page. Ensure
that you scroll over to the right of the screen to view all fields.
2. If comments are truncated, click "Show All" on the comments
REMEMBER: This draft is posted for your review for balloting purposes
only and should not be copied or redistributed.
NOTE: If you are fulfilling coordination duties only, you will not be
able to cast a vote. Coordinators can only submit comments. Please
follow the instructions above to access the document and submit your
***** QUESTIONS *****
If you should have any questions about the document, please contact
or the Sponsor Chair:
***** myBallot QUESTIONS *****
If you should have questions about using myBallot, please contact the
IEEE-SA Balloting Center at firstname.lastname@example.org
NOTE: To show our appreciation of your effort, the names of all voters
will be listed in the front matter of the published standard. Your vote
and your contact information will *not* be included.
Thank you for your participation in this ballot.
Bob Heile, Ph.D
Director of Standards, Wi-SUN Alliance
Chair, IEEE 802.15 Working Group on Wireless Specialty Networks
Chair IEEE 2030.5 Working Group for Smart Energy Profile 2
Co-Chair IEEE P2030 Task Force 3 on Smartgrid Communications
11 Robert Toner Blvd, Suite 5-301
North Attleboro, MA 02763 USA
This email is sent from the 802 Executive Committee email reflector. This list is maintained by Listserv.