SP #1: Do you agree on the following?
•802.11bp should define an AMP Authentication frame where part of the payload may be protected by the means of AES key wrap encapsulation/decapsulation algorithms (See 12.7.3)
•Note: This does not apply to mono static backscatter.
•Note: This does not apply to AMP-enabled non-AP STAs.
[Reference: 11-26/1347r1]
SP #2: Do you agree on the following?
•802.11bp should define a protected AMP Authentication frame that could be used to send an AMP de-authentication request.
•Note: This does not apply to mono static backscatter.
•Note: This does not apply to AMP-enabled non-AP STAs.
[Reference: 11-26/1347r1]
SP #3: Do you agree on the following?
•The protected AMP Authentication frame has AAD and encapsulation header components that are constructed as follow:
FC, TA and RA MAC header subfields are concatenated to form the AAD field (bit Masking is carried out in accordance with the logic set out in Clause 12.5.2.3.3 of the baseline standard).
•The Nonce is constructed using the AA and SA, and the 2 octets packet number incremented as specified Clause 12.5.2.3.4 of the baseline standard.
•The encapsulation header consists of the 2 octets packet number.
•Note: This does not apply to mono static backscatter.
•Note: This does not apply to AMP-enabled non-AP STAs.[Reference: 11-26/1347r1]
SP #4: Do you agree on the following?
•The size of the MIC field of the protected AMP Authentication Frame should be 4 octets.
•Note: This does not apply to mono static backscatter.
•Note: This does not apply to AMP-enabled non-AP STAs..
[Reference: 11-26/1347r1]
SP #5: Do you agree on the following?
•An AMP AP shall keep, and a non-AP AMP STA may keep an enumerated state variable for each STA with which direct communication is needed. This state variable expresses the relationship between the local STA and the remote STA. It takes on the following values:
•State 1: Initial start state (Unbonded and Unauthenticated)
•State 2: Bonded (pending Authentication or no possible Authentication)
•State 3: Bonded and Authenticated
•Note: This does not apply to mono static backscatter.
[Reference: 11-26/1348r1, 11-26/1346r1,
11-26/1347r1]
Regards,
G